 |
|
    |
|
    |
|
     |
|
|
Current list of Tools Available Updated weekly * NO REFUNDS ON TOOLS * I do not rent tools or take them back after you use them! |
| 000 |
 |
  |
| T09 | M1 Carbine Rear Sight installation/removal Tool- This is an excellent tool we had custom made to install or remove flip or ajustable rear sights on the carbine. The follower was designed to move the sight from the lowest part of the sight as not to cause damage to your sight or receiver, Place in your vise as you see in pictures. Top picture is installing sight and bottom picture is removing sight- just flip tool around in your vise for fast and easy use as you can see in the pictures(follower will not grind against your valuble sight as some cheaper ones will).This simply locks into any vice and all you have to do is slide in the receiver and use a 9/16 wrench on either side. Are sight tool will NOT damage your receiver like cheaper models that clamp down. Beware of clamp down models that can scratch or even crack your receiver if over tighten. The only part you have to remove from your carbine to use this tool is the trigger house. NOTE: The manufacture has improved the design of this tool making it smaller and easier to use while adding addition quality at the same time. MADE IN THE USA. |
|
 |
| T01 | M1 Carbine Receiver Wrench- Excellent quality- We had these custom made to fit your receiver snug. It will help to prevent scratching and damage to your receiver.This one will fit over the bottom lug like the GI model for a secure fit! MADE IN THE USA. |
|
  |
| T02 | M1 Carbine Barrel Block. MADE IN THE USA. |
|
 |
| T03 | M1 Carbine Piston Nut Wrench. We just found a small amount of these. |
|
 |
| T04 | M1 Carbine Front Sight Removal Tool. MADE IN THE USA. |
|
   |
| T13 | M1 Garand upper handguard tool. This is made so you can lock it in a vise and install the liner and ferule. Once you have everything in place just take a punch or your favorite tool and tap the tabs over the ferule and your done. Simple and easy. MADE IN THE USA. . |
|
 |
| T11 | M1 Carbine Front Sight Tool, assembling (for installing front sight) MADE IN THE USA. |
|
 |
| T05 | M1 Carbine Bolt Tool pawl. |
|
 |
| T08 | M1 Carbine USGI Bolt Tool. Very hard to find item and we are very low on supply. |
|
 |
| T10 | M1 Carbine Trigger Spring Tool-Brass |
|
 |
| T07 | M1 Carbine Bolt Tool |
|
 |
| T14 | M1 Garand Bolt Tool |
|
| 000 |
|
 GEORGE LIAKOS, OWNER P.O. BOX 85 RIVERBANK, CA 95367 (209) 869-5576 |