M1 Carbine Rear Sight Installation/Removal Tool

This is an excellent tool we had custom made to install or remove flip or adjustable rear sights on the carbine. The follower was designed to move the sight from the lowest part of the sight as not to cause damage to your sight or receiver, Place in your vise as you see in pictures. Top picture is installing sight and bottom picture is removing sight- just flip tool around in your vise for fast and easy use as you can see in the pictures(follower will not grind against your valuable sight as some cheaper ones will). This simply locks into any vice and all you have to do is slide in the receiver and use a 9/16 wrench on either side. Are sight tool will NOT damage your receiver like cheaper models that clamp down. Beware of clamp down models that can scratch or even crack your receiver if over tighten. The only part you have to remove from your carbine to use this tool is the trigger house. NOTE: The manufacture has improved the design of this tool making it smaller and easier to use while adding addition quality at the same time. MADE IN THE USA.